A special evaluator is not required, since the contact mat is composed of electro-mechanical break contacts, the signal of which can im-mediately be further processed. In addition to cost saving, any expensive connection and wiring actions are unnecessary. Valuable space is won on the crowded control panel. Further, of course, a not existing device cannot go defective.
Actuation will commence at low actuating forces and after a very short response travel, providing a fast response time. The full remaining height of the rubber profile is available as an over-travel. In particular with regard to the prevention of injuries, large over-travels are of enormous importance for a safety sensitive edge.
Haake supply devices having different materials and closing technologies for indoor or outdoor use, respectively. Our safety edges for outdoor use are vulcanised at the end caps, so that water is not an issue.Our safety mat meets the requirements of category 3 of EN 954-1 - even the sen-sor part. Double-channel design or redundancy is not necessary for this system, since the failure mode analysis made by BG has shown: a single fault does not lead to a loss of the safety function. This permits a simple construction of the system.
access sensing hazardous areas
safety mat category 3 EN 954-1
safety mat DIN EN 292-1
protection devices with approach reaction
attendance control hazardous area
safety shutt-off mat
HSM safety mat
saftey mat fixation bar
|safety mat, access sensing hazardous areas, safety mat category 3 EN 954-1, safety mat DIN EN 292-1, protection devices with approach reaction, attendance control hazardous area, safety shutt-off mat, contact mat, HSM safety mat, saftey mat fixation bar, pressure mat, automation, automotive, warehouse, machines, industry, plant, facility, hall, mechanical engineering, outdoors, outside, plant engineering, car manufacturing, indoors, inside, indoor use, outdoor use, assembly shop, factory building, storage room, storage place|