|
A special evaluator is not required, since the contact mat or contact mat is composed of electro-mechanical break contacts, the signal of which can im-mediately be further processed. In addition to cost saving, any expensive connection and wiring actions are unnecessary. Valuable space is won on the crowded control panel. Further, of course, a not existing device cannot go defective.
contact mat: Actuation will commence at low actuating forces and after a very short response travel, providing a fast response time. The full remaining height of the rubber profile is available as an over-travel. In particular with regard to the prevention of injuries, large over-travels are of enormous importance for a safety sensitive edge. Our safety mat and contact mat meet the requirements of category 3 of EN 954-1 - even the sen-sor part. Double-channel design or redundancy is not necessary for this contact mat - system, since the failure mode analysis made by BG has shown: a single fault does not lead to a loss of the safety function. This permits a simple construction of the system. Actuation will commence at low actuating forces and after a very short response travel, providing a fast response time. The full remaining height of the rubber profile is available as an over-travel. In particular with regard to the prevention of injuries, large over-travels are of enormous importance for a safety sensitive edge. |
contact matcontact mat safety mat access sensing hazardous areas safety mat category 3 EN 954-1 safety mat DIN EN 292-1 protection devices with approach reaction attendance control hazardous area safety shutt-off mat contact mat HSM safety mat saftey mat fixation bar pressure mat automation automotive warehouse machines industry plant facility hall mechanical engineering outdoors outside plant engineering car manufacturing indoors inside indoor use outdoor use assembly shop factory building storage room storage place |