|
A special evaluator is not required, since the contact mat or pressure mat is composed of electro-mechanical break contacts, the signal of which can im-mediately be further processed. In addition to cost saving, any expensive connection and wiring actions are unnecessary. Valuable space is won on the crowded control panel. Further, of course, a not existing device cannot go defective.
pressure mat: Actuation will commence at low actuating forces and after a very short response travel, providing a fast response time. The full remaining height of the rubber profile is available as an over-travel. In particular with regard to the prevention of injuries, large over-travels are of enormous importance for pressure mat. Machinery and devices presenting dangerous movements must be provided with an emergency stop device. This device is monitored by a suitable safety relay unit. Our safety mat and pressure mat meet the requirements of category 3 of EN 954-1 - even the sen-sor part. Double-channel design or redundancy is not necessary for this pressure mat - system, since the failure mode analysis made by BG has shown: a single fault does not lead to a loss of the safety function. This permits a simple construction of the system.pressure matpressure mat safety mat access sensing hazardous areas safety mat category 3 EN 954-1 safety mat DIN EN 292-1 protection devices with approach reaction attendance control hazardous area safety shutt-off mat contact mat HSM safety mat saftey mat fixation bar pressure mat automation automotive warehouse machines industry plant facility hall mechanical engineering outdoors outside plant engineering car manufacturing indoors inside indoor use outdoor use assembly shop factory building storage room storage place |